Happy birthday Cain and Cullen.....and Jason W! :)
Thanks so much for completing the following:
1. All dimensions are complete (#28, #30, #31). Once finished go back and dimension 2 earlier multiviews in your notebook (one in standard, one in metric). You can skip #32 (measuring with a dial caliper). If you are stuck, ask a buddy for help or use the dimensioning packet to guide you. Yes, I will be checking these along with the Isometric and multiviews that are in your notebook. I did not forget. :)
2. Take the quick assessment found on MyPLTW - lesson 1.3, step #26.
3. Use this time to practice reading a dial caliper, dimensioning, or using a ruler. Yes, there will be a quiz on this as well, so please make sure you are feeling confident. If not, practice with a buddy or help someone who is struggling. Thank you!
4. Again, for the first 20-25 minutes, you need to work, practice, or help someone. After that, you may have some free time IF your work is complete.
1. All dimensions are complete (#28, #30, #31). Once finished go back and dimension 2 earlier multiviews in your notebook (one in standard, one in metric). You can skip #32 (measuring with a dial caliper). If you are stuck, ask a buddy for help or use the dimensioning packet to guide you. Yes, I will be checking these along with the Isometric and multiviews that are in your notebook. I did not forget. :)
2. Take the quick assessment found on MyPLTW - lesson 1.3, step #26.
3. Use this time to practice reading a dial caliper, dimensioning, or using a ruler. Yes, there will be a quiz on this as well, so please make sure you are feeling confident. If not, practice with a buddy or help someone who is struggling. Thank you!
4. Again, for the first 20-25 minutes, you need to work, practice, or help someone. After that, you may have some free time IF your work is complete.
Transition points are doubled today! Be on your best and see you tomorrow.
Thanks,
Mrs. R.
No comments:
Post a Comment